Rear bumper, 5D |
Removing |
1. | Remove the bolts in the wheel housing. Pull out the bumper clips from the wheel housing edges and the rear wing. |
2. | Open the tailgate. |
3. | Remove the storage compartments and their covers on both sides. |
4. | Remove the insulation pads. The old ones must be discarded and replaced by new ones. |
5. | Remove the nuts holding the bumper. The lower bolts only have nuts if the car is equipped with a towbar.
|
6. | Lift away the bumper rearward with the help of an assistant.
|
Fitting |
Note | ||
For cars equipped with Saab Parking Assistance (SPA): | ||
• | Attach the connectors. |
1. | Put the bumper in position. |
2. | Press in the bumper shell over the wheel housing edge and the rear wing. Make sure the clips are correctly positioned. Fit the bolts in the wheel housing edge. |
3. | Tighten the nuts holding the bumper. |
4. | Fit the new insulation pads. |
5. | Fit the storage compartments and their covers on both sides. |
6. | Close the tailgate and check the fit of the bumper against the tailgate. |