SAAB WIS ONLINE

REPLACEMENT

REPLACEMENT

DRAINING OF ENGINE COOLANT

Lift-up the vehicle.

Remove the under cover.

Remove the drain cock to drain engine coolant into container.


Note

Remove the coolant filler tank cap so that engine coolant will drain faster.


Install the drain cock.

FILLING OF ENGINE COOLANT

Pour cooling system conditioner through the filler neck.

Fill engine coolant into the coolant filler tank up to filler neck position.

Coolant capacity (fill up to “FULL” level):

AT model

Approx. 7.6 litres (8.03 US qt, 6.69 Imp qt)

MT model

Approx. 7.7 litres (8.14 US qt, 6.78 Imp qt)

Important

Do not mix up the coolant filler tank side cap with radiator side cap.


Note
• Do not remove the radiator side cap when filling engine coolant.

• The Genuine Coolant containing anti-freeze and anti-rust agents is especially made for engine, which has an aluminum crankcase. Always use Genuine Coolant, since other coolant may cause corrosion.


Fill engine coolant into the reservoir tank up to Full level.


Warm-up the engine completely for more than 5 minutes at 2,000 to 3,000 rpm.

If the engine coolant level drops in coolant filler tank, add engine coolant to filler neck position.

If the engine coolant level drops from Full level of reservoir tank, add engine coolant to Full level.

Attach the coolant filler tank cap and reservoir tank cap properly.