ACTIVATION OF MALFUNCTION INDICATOR LIGHT

/ 9-2X (9346) / 2005 / 2. Engine / ENGINE (DIAGNOSTICS), 2.5i / Malfunction Indicator Light / Fault diagnosis, general / ACTIVATION OF MALFUNCTION INDICATOR LIGHT

When the ignition switch is turned to ON (engine off), the malfunction indicator light (A) in the combination meter illuminates.

Note
If the malfunction indicator light does not illuminate, perform diagnostics of the malfunction indicator light circuit or the combination meter circuit.

After starting the engine, the malfunction indicator light goes out. If it does not, either the engine or the emission control system is malfunctioning.

(1)	No trouble
(2)	Trouble occurs
(3)	ON
(4)	OFF
(5)	Ignition switch ON
(6)	Engine start

If the diagnosis system senses a misfire which could damage the catalyzer, the malfunction indicator light will blink at a cycle of 1 Hz.

(1)	ON
(2)	OFF
(3)	Ignition switch ON
(4)	Engine start
(5)	Misfire start
(6)	1 second

When the ignition switch is turned to ON (engine off) or to “START” with test mode connector connected, the malfunction indicator light blinks at a cycle of 3 Hz.

(1)	ON
(2)	OFF
(3)	Ignition switch ON
(4)	1 second

ACTIVATION OF MALFUNCTION INDICATOR LIGHT

Our Friends