SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Open the fuel filler flap lid.

Set the fuel saucer (A) with rubber packing (C) and insert the fuel filler pipe into hole from the inner side of apron.

Align the holes in fuel filler pipe neck and set the cup (B), and tighten the screws.

Note

If the edges of rubber packing are folded toward the inside, straighten it with a screwdriver.



Install the evaporation pipe.


Connect the evaporation hoses to fuel pipes.


Insert the fuel filler hose (A) approximately 35 to 40 mm (1.38 to 1.57 in) over the lower end of fuel filler pipe and tighten the clamp.

Insert the evaporation hose (B) approximately 25 to 30 mm (0.98 to 1.18 in) into the lower end of evaporation pipe and hold the clip.

Important

Do not allow clips to touch evaporation hose (B) and rear suspension crossmember.



L = 27.5±2.5 mm (1.083±0.098 in)


(1)

Hose

(2)

Clip

(3)

Pipe



Tighten the bolt which holds the fuel filler pipe bracket on the body.

Tightening torque:

7.5 Nm (0.75 kgf-m, 5.4 ft-lb)


Secure the evaporation hose to clip of fuel filler pipe.


Install the fuel filler pipe protector.


Install the rear right wheel.


Lower the vehicle.

Tighten the wheel nuts.

Connect the connector to the fuel pump relay.


Connect the battery ground cable to battery.