SAAB WIS ONLINE

ASSEMBLY

ASSEMBLY

Note

Replace the gasket with a new one.


Install the tumble generator valve assembly to the intake manifold.

Tightening torque:

8.25 Nm (0.84 kgf-m, 6.1 ft-lb)


Install the air intake duct to the intake manifold.

Tightening torque:

19 Nm (1.94 kgf-m, 13.7 ft-lb)


Install the fuel pipe assembly and pressure regulator to the intake manifold.

Tightening torque:

4.9 Nm (0.5 kgf-m, 3.6 ft-lb)


Install the fuel injector pipe LH.

Connect the left side fuel hose to injector pipe, and tighten the clamp screw.


Install the engine harness to the intake manifold.

Install the harness bracket which holds the engine harness onto intake manifold.

Tightening torque:

19 Nm (1.94 kgf-m, 13.7 ft-lb)


Install the fuel injector.


Tighten the bolts which install the fuel injector pipe onto intake manifold.

Tightening torque:

19 Nm (1.94 kgf-m, 13.7 ft-lb)


• LH SIDE



• RH SIDE




Tighten the two bolts which install the fuel pipes on the left side of intake manifold.

Tightening torque:

4.9 Nm (0.5 kgf-m, 3.6 ft-lb)


Connect the evaporation hoses to the purge valve.

Note

Connect the evaporation hoses as shown in the figure.



(A)

To fuel pipe ASSY

(B)

To intake duct

(C)

To purge control solenoid valve

(D)

To intake manifold



Connect the evaporation hose to the intake manifold.


Install the purge control solenoid valve.

Tightening torque:

16 Nm (1.6 kgf-m, 11.8 ft-lb)


Connect the hoses to the purge control solenoid valve.

Note

Connect the evaporation hoses as shown in the figure.



(A)

To intake manifold

(B)

To purge valve



Connect the connector to the purge control solenoid valve.


Connect the connector to the tumble generator valve sensor.


Connect the connector to the tumble generator valve actuator.


Connect the connector to the fuel injector.


Install the throttle body to the intake manifold.

Note

Replace the gasket with a new one.


Tightening torque:

22 Nm (2.2 kgf-m, 15.9 ft-lb)


Connect the connector to the throttle position sensor (A), idle air control solenoid valve (B) and manifold absolute pressure sensor (C).

Connect the engine harness to the intake manifold using clips (D).


Install the engine ground terminal to the intake manifold.

Tightening torque:

19 Nm (1.94 kgf-m, 13.7 ft-lb)



Install the fuel pipe protector RH.

Tightening torque:

19 Nm (1.94 kgf-m, 13.7 ft-lb)


Install the fuel pipe protector LH.

Tightening torque:

19 Nm (1.94 kgf-m, 13.7 ft-lb)