DISASSEMBLY
| DISASSEMBLY |
Remove the fuel pipe protector LH.
Remove the engine ground terminal from the intake manifold.
Disconnect the connector from the throttle position sensor (A), idle air control solenoid valve (B) and manifold absolute pressure sensor (C).
Disconnect the engine harness fixed by clip (D) from the intake manifold.
Remove the throttle body from the intake manifold.
Disconnect the connector from the fuel injector.
Disconnect the connector from the tumble generator valve actuator.
Disconnect the connector from the tumble generator valve sensor.
Disconnect the connector from the purge control solenoid valve.
Remove the purge control solenoid valve.
Disconnect the evaporation hose from the intake manifold.
Disconnect the evaporation hoses from the purge valve.
Remove the two bolts which hold the fuel pipes on the left side of intake manifold.
Remove the bolt which hold the fuel injector pipe onto intake manifold.
| • |
LH SIDE
|
|
| • |
RH SIDE
|
|
Remove the fuel injector.
Remove the harness bracket which holds the engine harness onto intake manifold.
Remove the engine harness from the intake manifold.
Loosen the clamp which holds the front left side fuel hose to injector pipe and remove the pipe from clamp.
Remove the fuel injector pipe LH.
Remove the bolts which install the fuel pipe on intake manifold.
Remove the fuel pipe assembly and pressure regulator, from the intake manifold.
Remove the intake duct from the intake manifold.
Remove the tumble generator valve assembly from the intake manifold.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
