SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Support the fuel tank with a transmission jack and push the fuel tank harness into the access hole with the grommet.

Set the fuel tank and temporarily tighten the bolts of fuel tank bands.

Warning

An assistant is required to perform this work.



Insert the fuel filler hose (A) approx. 35 to 40 mm (1.38 to 1.57 in) over the lower end of fuel filler pipe, and tighten the clamp.

Insert the evaporation hose (B) to the lower end of evaporation pipe, and hold the clamp and clip.


Important

Do not allow clips to touch hose (A) and rear suspension crossmember.



Connect the fuel hoses, and hold them with clips and quick connector.


Connect the connector to the pressure control solenoid valve.

Install the canister.

Tighten the band mounting bolts.

Tightening torque:

33 Nm (3.4 kgf-m, 25 ft-lb)


Install the rear crossmember.

Connect the connectors (A) to the fuel tank cord and plug the service hole with grommet (B).


Set the rear seat and floor mat.

Connect the connector to the fuel pump relay.