SAAB WIS ONLINE

PROCEDURE

PROCEDURE

RELEASING OF FUEL PRESSURE

Warning
• Place “NO FIRE” signs near the working area.

• Be careful not to spill fuel on the floor.


Disconnect the connector from the fuel pump relay.


Start the engine and run it until it stalls.

After the engine stalls, crank it for five more seconds.

Turn the ignition switch to OFF.

DRAINING FUEL

Warning
• Place “NO FIRE” signs near the working area.

• Be careful not to spill fuel on the floor.


Set the vehicle on a lift.

Disconnect the ground cable from battery.


Open the fuel filler flap lid, and then remove the fuel filler cap.

Lift up the vehicle.

Drain the fuel from the fuel tank.

Set a container under the vehicle and remove the drain plug from the fuel tank.


Tighten the fuel drain plug.

Note

Use a new gasket


Tightening torque:

26 Nm (2.65 kgf-m, 19.2 ft-lb)