DISASSEMBLY
| DISASSEMBLY |
Disconnect the engine ground terminal from intake manifold.
Remove the throttle body.
Remove the EGR valve.
Remove the PCV pipe.
Remove the fuel pipe protector LH.
Remove the fuel pipe protector RH.
Disconnect the pressure regulator vacuum hose (A) from intake manifold.
Disconnect the connectors (A) from fuel injector.
Remove the harness band (B) which holds engine harness to injector pipe.
Remove the purge control solenoid valve.
Remove the harness band clips which install the engine harness.
Remove the bolts which hold the engine harness to intake manifold.
Remove the engine harness from intake manifold.
Remove the bolts which install injector pipe on the intake manifold as shown in the figure.
| • |
RH side
|
|
| • |
LH side
|
|
Remove the fuel injectors from injector pipe.
Loosen the clamp which holds fuel injector pipe RH to fuel hose, and then disconnect the pipe from fuel hose.
Loosen the clamp which holds fuel injector pipe LH to fuel hose, and then disconnect the pipe from fuel hose.
Remove the fuel injector pipe.
Remove the bolt which installs pressure regulator on intake manifold.
Remove the bolt which installs the fuel pipes on intake manifold.
Remove the fuel pipe assembly and pressure regulator, from intake manifold.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
