SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Important

Before installing the oil pan, clean sealant from oil pan and engine block.


Install the baffle plate.

Tightening torque:

6.4 Nm (0.65 kgf-m, 4.7 ft-lb)


Install the oil strainer onto baffle plate.

Note

Replace the O-ring with a new one.


Tightening torque:

10 Nm (1.0 kgf-m, 7.2 ft-lb)


Apply fluid packing to the mating surfaces, and then install the oil pan.

Fluid packing:

THREE BOND 1207C (Part No. 32005015) or equivalent


Tighten the bolts which install the oil pan onto engine block.

Tightening torque:

5 Nm (0.5 kgf-m, 3.6 ft-lb)


Lower the engine onto front crossmember.

Tighten the nuts which install the front cushion rubber onto front crossmember.

Tightening torque:

83 Nm (8.5 kgf-m, 61 ft-lb)


Install the under cover.

Lower the vehicle.

Important

When lowering the vehicle, lower the lifting device and wire rope together.


Remove the lifting device and steel cables.


Install the pitching stopper.

Tightening torque:

T1: 50 Nm (5.1 kgf-m, 36.9 ft-lb)

T2: 58 Nm (5.9 kgf-m, 42.8 ft-lb)


Install the radiator upper brackets.


Install the intercooler.

Install the air intake boot and air cleaner upper cover.


Connect the connector to mass air flow sensor.


Install the front wheels.

Connect the battery ground cable to battery.


Fill engine oil.