SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Install the crank pulley.

Install the pulley bolt.

To lock the crankshaft, use ST.

ST 32005163 CRANK PULLEY WRENCH

Clean the crankshaft thread using compressed air.

Apply engine oil to the crank pulley bolt seat and thread.

Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kgf-m, 33 ft-lb).

Tighten the crank pulley bolts.

Tightening torque:

180 Nm (18.4 kgf-m, 132.8 ft-lb)


Confirm that the tightening angle of crank pulley bolt is 65 degrees or more. If the tightening angle of crank pulley bolt is less than 65 degrees, conduct the following procedures.

Replace the crank pulley bolts and clean them.

Crank pulley bolt:

32005529

Clean the crankshaft thread using compressed air.

Apply engine oil to the crank pulley bolt seal and thread.

Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kgf-m, 33 ft-lb).

Tighten the crank pulley bolts keeping them in an angle between 65 degrees and 75 degrees.

Note

Conduct the tightening procedures by confirming the turning angle of crank pulley bolt referring to the gauge indicated on timing belt cover.


Install the A/C belt tensioner.


Install the V-belt.