INSPECTION
| INSPECTION |
When any on-board diagnostics item is malfunctioning, the display on AT OIL TEMP warning light blinks from the time malfunction is detected after starting the engine until ignition switch is turned to OFF. The malfunctioning part or unit can be determined by a DTC during on-board diagnostics operation. Problems which occurred previously can also be identified through the memory function. If the AT OIL TEMP warning light does not show a problem (although a problem is occurring), the problem can be determined by checking the performance characteristics of each sensor using Vehicle Diagnostic Interface. The AT OIL TEMP warning light signal is as shown in the figure.
|
(1)
|
Ignition
switch (Engine OFF)
|
(4)
|
Faulty
(Engine ON)
|
(7)
|
Normal
(ATF temperature is high)
|
|
(2)
|
Normal (Engine
ON)
|
(5)
|
0.25 seconds
|
(8)
|
ATF temperature
is high
|
|
(3)
|
2 seconds
|
(6)
|
Blink
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
