DTC 36 TORQUE CONVERTER TURBINE SPEED SENSOR

DTC 36 TORQUE CONVERTER TURBINE SPEED SENSOR

CHECK HARNESS CONNECTOR BETWEEN TCM AND TRANSMISSION.

Disconnect the connector from TCM.

Measure the resistance of harness between TCM and transmission connector.

Connector & terminal

(B55) No. 8 — (B11) No. 14:

Is the resistance less than 1 Ω?

Yes

No

Repair the open circuit in harness between TCM and transmission connector.

CHECK HARNESS CONNECTOR BETWEEN TCM AND TRANSMISSION.

Measure the resistance of harness between TCM and transmission connector.

Connector & terminal

(B55) No. 9 — (B11) No. 15:

Is the resistance less than 1 Ω?

Yes

No

Repair the open circuit in harness between TCM and transmission connector, and poor contact in coupling connector.

CHECK HARNESS CONNECTOR BETWEEN TCM AND TRANSMISSION.

Measure the resistance of harness between TCM and chassis ground.

Connector & terminal

(B55) No. 9 — Chassis ground:

Is the resistance more than 1 MΩ?

Yes

No

Repair the short circuit in harness between TCM and transmission connector.

CHECK HARNESS CONNECTOR BETWEEN TCM AND TRANSMISSION.

Measure the resistance of harness between TCM and chassis ground.

Connector & terminal

(B55) No. 8 — Chassis ground:

Is the resistance more than 1 MΩ?

Yes

No

Repair the short circuit in harness between TCM and transmission connector, and poor contact in coupling connector.

CHECK TORQUE CONVERTER TURBINE SPEED SENSOR.

Turn the ignition switch to OFF.

Disconnect the connector from transmission.

Measure the resistance between transmission connector receptacle’s terminals.

Connector & terminal

(T4) No. 14 — No. 15:

Is the resistance 450 — 650 Ω?

Yes

No

Replace the turbine speed sensor.

CHECK INPUT SIGNAL FOR TCM USING Vehicle Diagnostic Interface.

Connect the connectors to TCM and transmission.

Connect the Vehicle Diagnostic Interface to data link connector.

Turn the ignition switch to ON and turn Vehicle Diagnostic Interface switch to ON.

Start the engine.

Move the select lever to “P” or “N” range.

Read the data of turbine speed using Vehicle Diagnostic Interface.

•	Compare the tachometer with Vehicle Diagnostic Interface indications.

Is the revolution value same as the tachometer reading shown on the combination meter?

Yes

Even if the AT OIL TEMP warning light blinks, the circuit has returned to a normal condition at this time. A temporary poor contact of the connector or harness may be the cause. Repair the harness or connector in TCM and transmission.

No

CHECK POOR CONTACT.

Is there poor contact in torque converter turbine speed sensor circuit?

Yes

Repair the poor contact.

No

Replace the TCM.