SAAB WIS ONLINE

DTC 93 REAR VEHICLE SPEED SENSOR

DTC 93 REAR VEHICLE SPEED SENSOR

DIAGNOSIS:

The input signal circuit of TCM is open or shorted.

TROUBLE SYMPTOM:

Tight corner braking phenomenon.

WIRING DIAGRAM:


CHECK HARNESS CONNECTOR BETWEEN TCM AND TRANSMISSION.

Turn the ignition switch to OFF.

Disconnect the connector from TCM and transmission.

Measure the resistance of harness between TCM and transmission connector.

Connector & terminal

(B55) No. 24 — (B11) No. 19:

Is the resistance less than 1 Ω?

Yes


No

Repair the open circuit in harness between TCM and transmission connector.


CHECK HARNESS CONNECTOR BETWEEN TCM AND TRANSMISSION.

Measure the resistance of harness between TCM and transmission connector.

Connector & terminal

(B54) No. 19 — (B11) No. 20:

Is the resistance less than 1 Ω?

Yes


No

Repair the open circuit in harness between TCM and transmission, and poor contact in coupling connector.


CHECK HARNESS CONNECTOR BETWEEN TCM AND TRANSMISSION.

Measure the resistance of harness between TCM and chassis ground.

Connector & terminal

(B55) No. 24 — Chassis ground:

Is the resistance more than 1 MΩ?

Yes


No

Repair the short circuit in harness between TCM and transmission connector.


CHECK HARNESS CONNECTOR BETWEEN TCM AND TRANSMISSION.

Measure the resistance of harness between TCM and chassis ground.

Connector & terminal

(B54) No. 19 — Chassis ground:

Is the resistance more than 1 MΩ?

Yes


No

Repair the short circuit in harness between TCM and transmission connector.


CHECK REAR VEHICLE SPEED SENSOR.

Measure the resistance between transmission connector receptacle’s terminals.

Connector & terminal

(T4) No. 19 — No. 20:

Is the resistance 450 — 650 Ω?

Yes


No

Replace the rear vehicle speed sensor.


CHECK INPUT SIGNAL FOR TCM USING Vehicle Diagnostic Interface.

Connect the connectors to TCM and transmission.

Connect the Vehicle Diagnostic Interface to data link connector.

Lift-up or raise the vehicle and place rigid racks.

Note

Raise all wheels off floor.


Turn the ignition switch to ON and turn Vehicle Diagnostic Interface switch to ON.

Start the engine.

Read the data of vehicle speed using Vehicle Diagnostic Interface.


• Compare the speedometer with Vehicle Diagnostic Interface indications.

• Vehicle speed is indicated in “km/h” or “MPH”.


Slowly increase the vehicle speed to 60 km/h or 37 MPH.

Note

The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunction. When AT control diagnosis is finished, perform the ABS memory clearance procedure of on-board diagnostics system.


Does the speedometer indication increase as the Vehicle Diagnostic Interface data increases?

Yes

Even if the AT OIL TEMP warning light blinks, the circuit has returned to a normal condition at this time. A temporary poor contact of the connector or harness may be the cause. Repair the harness or connector in TCM and transmission.


No


CHECK POOR CONTACT.

Is there poor contact in rear vehicle speed sensor circuit?

Yes

Repair the poor contact.


No

Replace the TCM.