INSTALLATION
INSTALLATION |
Saab 9-2X 2.0T Aero |
Set the range select lever in āNā range.
Install the control valve, ATF temperature sensor and ground connectors.
Tightening torque:
8 Nm (0.8 kgf-m, 5.8 ft-lb)
Bolt length
mm (in)
|
|
(A)
|
30 (1.18)
|
(B)
|
55 (2.17)
|
Connect all connectors.
(A)
|
Lock-up
duty solenoid (Blue)
|
(B)
|
Low clutch
timing solenoid (Gray)
|
(C)
|
Line pressure
duty solenoid (Red)
|
(D)
|
Shift solenoid
2 (Yellow)
|
(E)
|
Shift solenoid
1 (Green)
|
(F)
|
2-4 brake
timing solenoid (Black)
|
(G)
|
2-4 brake
duty solenoid (Red)
|
(H)
|
Transfer
duty solenoid (Brown)
|
Attach the magnet at specified position.
Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:
THREE BOND 1217B (Part No. 32005004)
Apply liquid gasket fully to three holes other than screw holes on transmission case.
Liquid gasket:
THREE BOND 1217B (Part No. 32005004)
Install the oil pan by equally tightening the bolts.
Tightening torque:
5 Nm (0.5 kgf-m, 3.6 ft-lb)
Pour ATF from the oil charge pipe.
Recommended fluid:
Dexron III
Fluid capacity:
Fill the same amount of fluid drained from drain plug hole.
Check the level of ATF.
Saab 9-2X 2.5i Linear |
Check the control valve body for dirt and dust.
Temporarily install the control valve body to transmission.
Install the oil cooler pipe.
Tightening torque:
8 Nm (0.8 kgf-m, 5.8 ft-lb)
Tighten the bolts evenly.
Tightening torque:
8 Nm (0.8 kgf-m, 5.8 ft-lb)
(A)
|
Transmission
ground
|
Bolt length
mm (in)
|
|
(1)
|
35 (1.38)
|
(2)
|
30 (1.18)
|
Attach the magnet at specified position of oil pan.
Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:
THREE BOND 1217B (Part No. 32005004)
Apply liquid gasket fully to three holes other than screw holes on transmission case.
Liquid gasket:
THREE BOND 1217B (Part No. 32005004)
Install the oil pan with tightening bolts evenly.
Tightening torque:
5 Nm (0.5 kgf-m, 3.6 ft-lb)
Pour ATF into the oil charge pipe.
Recommended fluid:
Dexron III type automatic transmission fluid
Fluid capacity:
Fill the same amount of fluid drained from drain plug hole.
Bleed the air from control valve.
Check the level of ATF.
Perform the advance operation of learning control. (Saab 9-2X 2.5i Linear)