ASSEMBLY

ASSEMBLY

MPT MODEL

Using the ST and a press, press in a new oil seal.

ST 32005087 INSTALLER

Press in the dust cover.

Install the transfer clutch pipe to extension case without deforming pipe.

(A)	Extension case
(B)	Transfer clutch pipe

Install the transfer clutch assembly to the case.

Note
•	Be careful not to damage the seal rings.
•	Insert the clutch assembly fully into position until the bearing shoulder bottoms.

(A)	Transfer clutch
(B)	Extension case

VTD MODEL

Press new oil seal using ST and a press.

ST 32005087 INSTALLER

Press dust cover.

Install the transfer clutch pipe onto the extension case, taking care not to deform the pipe.

Apply ATF to new O-ring and install the test plug.

Tightening torque:

13 Nm (1.3 kgf-m, 9.4 ft-lb)

(A)	Test plug
(B)	Extension case

Insert the multi-plate clutch, drive plates, driven plates, and spring retainer.

(A)	Spring retainer
(B)	Multi-plate clutch (LSD) piston assembly

Install the snap ring using special tools 1, 2, and 3.

ST1 32005075 COMPRESSOR

ST2 32005112 SEAT

ST3 32005074 PLIERS