INSTALLATION
| INSTALLATION |
Attach the selected thrust needle bearing to the end surface of reduction drive gear with vaseline.
| Note | ||
|
Install thrust needle bearing in the correct direction. |
Install new gasket.
Install the extension case to the transmission case.
Tighten bolts to secure the case.
Tightening torque:
25 Nm (2.5 kgf-m, 18.1 ft-lb)
Tightening torque:
7 Nm (0.7 kgf-m, 5.1 ft-lb)
| • |
MPT MODEL
|
|||
| • |
VTD MODEL
|
|||
Install the transmission assembly.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
