SAAB WIS ONLINE

DISASSEMBLY

DISASSEMBLY

DIFFERENTIAL CASE ASSEMBLY

Using a press and ST, remove the taper roller bearing.

ST 32005088 REMOVER


Secure the case in a vise and remove the hypoid driven gear tightening bolts, then separate the hypoid driven gear, case (RH) and case (LH).


(A)

Hypoid driven gear

(B)

Differential case (RH)

(C)

Differential case (LH)



Pull out the straight pin and shaft, and remove the differential bevel gear, washer, and differential bevel pinion.


(A)

Differential case (RH)



SIDE RETAINER

Note

After adjusting the drive pinion backlash and tooth contact, remove and install the oil seal and O-ring.


Remove O-ring.


Remove oil seal.


Take out either split pin, remove claw.

ST 32005071 PULLER ASSY


(A)

Claw

(B)

Split pin

(C)

Pin



Securely attach two claws to outer race, set ST to side retainer.

ST 32005071 PULLER ASSY


(A)

Shaft

(B)

Claw



Return removed claw to the original position, and install pin and split pin.

Hold the shaft of ST to avoid removing from side retainer, and then remove the bearing outer race.

ST 32005071 PULLER ASSY

Note

Replace bearing inner and outer races as a single unit.



(A)

Shaft

(B)

Side retainer