SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Install the transfer duty solenoid and transfer valve body.

Install the transfer duty solenoid and transfer valve body.

Tightening torque:

T: 8 Nm (0.8 kgf-m, 5.8 ft-lb)

Connect the transfer duty solenoid connector.


(A)

Transfer valve body

(B)

Transfer duty solenoid connector

(C)

Transfer duty solenoid



Install a new gasket and the extension case to transmission case.

Tighten eleven bolts.

Tightening torque:

25 Nm (2.5 kgf-m, 18.1 ft-lb)

Adjust the select cable.

Install the rear vehicle speed sensor.

Tightening torque:

T: 7 Nm (0.7 kgf-m, 5.1 ft-lb)


Install the transmission rear crossmember.

Tighten the bolts.

Tightening torque:

T1: 35 Nm (3.6 kgf-m, 26 ft-lb)

T2: 70 Nm (7.1 kgf-m, 51 ft-lb)


Remove the transmission jack.

Install the propeller shaft.

Install center and rear exhaust pipes, and muffler.

Connect the transmission harness connector.


Install the pitching stopper.

Tightening torque:

T1: 50 Nm (5.1 kgf-m, 37 ft-lb)

T2: 58 Nm (5.9 kgf-m, 43 ft-lb)


Install intercooler. (Saab 9-2X 2.0T Aero)



Fill ATF up to the middle of the “COLD” side on level gauge by using the gauge hole.

Check the ATF level.