REMOVAL
| REMOVAL |
Remove the transmission assembly from the vehicle.
Extract the torque converter clutch assembly.
Remove the input shaft.
Lift-up lever behind the transmission harness connector and disconnect it from stay.
Disconnect the air breather hoses.
Disconnect inhibitor switch connector from stay.
Wrap vinyl tape around the nipple attached to the air breather hose.
Remove pitching stopper bracket.
Remove the inhibitor switch.
Pull off the straight pin of manual plate.
Remove bolts securing select lever, then remove select lever, manual plate and parking rod.
| Note | ||
|
Be careful not to damage the lips of the press-fitted oil seal in the case. |
|
(A)
|
Bolt
|
|
(B)
|
Range select
lever
|
|
(C)
|
Manual
plate
|
|
(D)
|
Parking
rod
|
Remove the detention spring.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
