SAAB WIS ONLINE

REPLACEMENT

REPLACEMENT

Set the vehicle on a lift.

Disconnect the ground cable from battery.

Move the select lever or gear shift lever to “N”.

Release the parking brake.

Remove the oil drain plug, and drain the gear oil.


(A)

Filler plug

(B)

Drain plug



Install the oil drain plug.

Note

Apply liquid gasket to the drain plug.


Liquid gasket:

THREE BOND 1105 (Part No.32005014) or equivalent.

Tightening torque:

49 Nm (5.0 kgf-m, 36.2 ft-lb)

Jack-up the vehicle and support with sturdy racks.

Remove the rear exhaust pipe and muffler.

Remove the propeller shaft from body.

Remove the self-locking nut while holding the companion flange with ST.

ST 32005101 FLANGE WRENCH


Remove the tank cover.


Extract the companion flange using ST.

ST 32005080 PULLER ASSY


Remove the oil seal using ST.

ST 32005071 PULLER ASSY


Fit a new oil seal using ST.

ST 32005104 INSTALLER


Install the companion flange.

Note

Use a plastic hammer to install the companion flange.


Tighten the self-locking nut within the specified torque range so that the preload of companion flange becomes the same as that before replacing oil seal.

ST 32005101 FLANGE WRENCH

Note

Use a new self-locking nut.


Tightening torque:

181 Nm (18.5 kgf-m, 134 ft-lb)


Hereafter, reassemble in the reverse order of disassembly.

Fill the differential carrier with gear oil to the bottom of filler plug hole after installing.