SAAB WIS ONLINE

ASSEMBLY

ASSEMBLY

Note

When the hub is to be removed from housing, replace the bearing set and oil seal with new ones.


Using the ST, press the new hub bolt into place.

Note
• Ensure the hub bolt closely contacts the hub.

• Use a 12 mm (0.47 in) hole in the ST to prevent the hub bolt from tilting during installation.


ST 32005200 HUB STAND


Remove foreign particles (dust, rust, etc.) from mating surfaces of the hub tone wheel, and then install the tone wheel to hub.

Note
• Ensure the tone wheel closely contacts the hub.

• Be careful not to damage the tone wheel teeth.



(1)

Tone wheel



Clean the housing interior completely. Using the ST1 and ST2, press the bearing into housing.

ST1 32005209 HOUSING STAND

ST2 32005210 BEARING REMOVER

Note

Be careful not to remove the plastic lock from inner race when installing the bearing.



Using pliers, install the snap ring firmly.


(1)

Pliers



Using the ST1 and ST2, press the outer oil seal until it comes in contact with snap ring.

ST1 32005209 HOUSING STAND

ST2 32005212 OIL SEAL INSTALLER


(1)

Snap ring



Invert both ST1 and housing.

Using the ST2, press the inner oil seal into housing until it touches the bottom.

ST1 32005209 HOUSING STAND

ST2 32005212 OIL SEAL INSTALLER


Using the ST1 and ST2, press the sub seal into place.

ST1 32005209 HOUSING STAND

ST2 32005212 OIL SEAL INSTALLER


Apply sufficient grease to oil seal lip.

Specified grease:

SHELL 6459N

Note
• If specified grease is not available, remove the bearing grease and apply Auto Rex A instead.

• Do not mix different types of grease.


Install the back plate to rear housing.

Tightening torque:

52 Nm (5.3 kgf-m, 38.3 ft-lb)

Using the ST1 and ST2, press the bearing into hub.

ST1 32005200 HUB STAND

ST2 32005211 HUB INSTALLER


(1)

Back plate