SAAB WIS ONLINE

DISASSEMBLY

DISASSEMBLY

Using the ST1 and ST2, remove the hub from rear housing.

ST1 32005200 HUB STAND

ST2 32005208 HUB REMOVER


Remove the back plate from rear housing.

Using a standard screwdriver, remove the outer and inner oil seals.

Using a flat tip screwdriver, remove the snap ring.

Note

Be careful not to damage the housing at removal.



Using the ST1 and ST2, remove the bearing by pressing the inner race.

ST1 32005209 HOUSING STAND

ST2 32005210 BEARING REMOVER


Remove the tone wheel bolts, and then remove the tone wheel from hub.

Using the ST, press the hub bolt out.

ST 32005200 HUB STAND

Important

Be careful not to hammer the hub bolts. This may deform the hub.