SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Insert the rear drive shaft into rear axle.

Temporarily tighten the axle nut.

Install the rear drive shaft to rear differential using the ST.

ST 32005037 OIL SEAL PROTECTOR


Temporarily tighten the front lateral link and rear lateral link to housing using a new self-locking nuts.


Temporarily tighten the trailing link to housing using a new self-locking nut.


Install the stabilizer link.

Tightening torque:

45 Nm (4.6 kgf-m, 33 ft-lb)


Install the ABS wheel speed sensor.

Tightening torque:

32 Nm (3.3 kgf-m, 24 ft-lb)


(1)

ABS wheel speed sensor



Using the ST1 and ST2, pull the rear drive shaft into place.

ST1 32005184 AXLE SHAFT INSTALLER

ST2 32005205 ADAPTER


Tighten a new axle nut to the specified torque with parking brake applied.

Tightening torque:

190 Nm (19.4 kgf-m, 140 ft-lb)

Lock the axle nut.


Install the wheel.

Tightening torque:

90 Nm (9.2 kgf-m, 66 ft-lb)

Make the tires contact the ground fully.

Important

Make the tires contact the ground fully and the vehicle be in curb weight whenever carrying out the tightening of bush portions.


Tighten the installation bolt of rear housing assembly and lateral link assembly.

Tightening torque:

140 Nm (14.3 kgf-m, 103 ft-lb)

Tighten the installation bolt of rear housing assembly and trailing link assembly.

Tightening torque:

90 Nm (9.2 kgf-m, 66 ft-lb)