CAUTION
| CAUTION |
| • |
Wear working
clothing, including a cap, protective goggles and protective shoes
during operation.
|
|
| • |
Remove contamination including dirt and corrosion before
removal, installation, and disassembly.
|
|
| • |
Keep the disassembled parts in order and protect them
from dust or dirt.
|
|
| • |
Before removal, installation or disassembly, be sure
to clarify the failure. Avoid unnecessary removal, installation,
disassembly and replacement.
|
|
| • |
When disassembling the case and other light alloy parts,
use a plastic hammer to force it apart. Do not pry it apart with
a screwdriver or other tool.
|
|
| • |
Be careful not to burn yourself, because each part on
the vehicle is hot after running.
|
|
| • |
Use genuine gear oil, grease etc. or the equivalent.
Do not mix gear oil, grease etc. with that of another grade or from
other manufacturers.
|
|
| • |
Be sure to tighten fasteners including bolts and nuts
to the specified torque.
|
|
| • |
Place shop jacks or rigid racks at the specified points.
|
|
| • |
Apply gear oil onto sliding or revolution surfaces before
installation.
|
|
| • |
Replace deformed or otherwise damaged snap rings with
new ones.
|
|
| • |
Before installing O-rings or oil seals, apply sufficient
amount of gear oil to avoid damage and deformation.
|
|
| • |
Be careful not to incorrectly install or fail to install O-rings,
snap rings and other such parts.
|
|
| • |
Before securing a part on a vise, place cushioning material
such as wood blocks, aluminum plate, or shop cloth between the part
and the vise.
|
|
| • |
Avoid damaging the mating surface of the case.
|
|
| • |
Before applying sealant, completely remove the old seal.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
