ADJUSTMENT
ADJUSTMENT |
NEUTRAL POSITION ADJUSTMENT |
Shift the gear into 3rd gear position.
Shifter arm turns lightly toward the 1st/2nd gear side but heavily toward the reverse gear side because of the function of return spring, until arm contacts the stopper.
Make adjustment so that the heavy stroke (reverse side) is a little more than the light stroke (1st/2nd side).
To adjust, remove the bolts holding reverse check sleeve assembly to the case, move the sleeve assembly outward, and place adjusting shim (0 to 1 ea.) between sleeve assembly and case to adjust the clearance.
Important | ||
Be careful not to break the O-ring when placing shim(s). |
||
Note | ||
• |
When the shim is removed, the neutral position will
move closer to reverse; when shim is added, the neutral position
will move closer to 1st gear.
|
|
• |
If the shims alone cannot adjust clearance, replace
the reverse accent shaft and re-adjust.
|
Adjusting shim | |
Part No. | Thickness mm (in) |
32006705
|
0.15
(0.0059)
|
32006706
|
0.30
(0.0118)
|
Reverse accent shaft
|
||
Part
No.
|
Mark
|
Remarks
|
32006697
|
S
|
Neutral
position is closer to 1st gear.
|
32006698
|
T
|
Standard
|
32006699
|
U
|
Neutral
position is closer to reverse gear.
|
REVERSE CHECK PLATE ADJUSTMENT |
Shift the shifter arm to “5th” and then to reverse to see if reverse check mechanism operates properly.
Also check to see if the arm returns to neutral when released from reverse position. If the arm does not return properly, replace the reverse check plate.
Reverse check plate | |||
Part No. | (A): No. | Angle &thetas; | Remarks |
32006700
|
0
|
28°
|
Arm
stops closer to 5th gear.
|
32006701
|
1
|
31°
|
Arm
stops closer to 5th gear.
|
32006702
|
2
|
34°
|
Arm
stops in the center.
|
32006703
|
3
|
37°
|
Arm
stops closer to reverse gear.
|
32006704
|
4
|
40°
|
Arm
stops closer to reverse gear.
|