SAAB WIS ONLINE

INSTALLATION

INSTALLATION

PITCHING STOPPER

Install the pitching stopper.

Tightening torque:

T1: 50 Nm (5.1 kgf-m, 37 ft-lb)

T2: 58 Nm (5.9 kgf-m, 43 ft-lb)


Install the air intake duct and cleaner case. (Saab 9-2X 2.5i Linear)

and

Install the intercooler. (Saab 9-2X 2.0T Aero)



Connect the battery ground cable to battery.

CROSSMEMBER AND CUSHION RUBBER

Install the rear cushion rubber.

Tightening torque:

35 Nm (3.6 kgf-m, 26 ft-lb)

Install the rear crossmember.

Tightening torque:

T1: 70 Nm (7.1 kgf-m, 51 ft-lb)

T2: 140 Nm (14.3 kgf-m, 103 ft-lb)


Remove the transmission jack.

Install the heat shield cover. (If equipped)

Install the front and center exhaust pipes. (Saab 9-2X 2.5i Linear)



Install the center exhaust pipe. (Saab 9-2X 2.0T Aero)

Install the rear exhaust pipe and muffler.