SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Note
Discard the vehicle speed sensor and after removal, replace with a new one.

Ensure the sensor mounting hole is clean and free of foreign matter.

Align the tip end of key with key groove on end of speedometer shaft during installation.


Hand tighten the vehicle speed sensor.

Tighten the vehicle speed sensor using suitable tool.

Tightening torque:

5.9 Nm (0.6 kgf-m, 4.3 ft-lb)

Connect the connector to vehicle speed sensor.

Install the front, center exhaust pipes and muffler.

Lower the vehicle.

Connect the battery ground cable to battery.