DISASSEMBLY
| DISASSEMBLY |
| 15 INCH TYPE & 16 INCH TYPE |
Clean mud and foreign particles from the caliper body assembly and support.
| Important | ||
|
Be careful not to allow foreign particles to enter the brake hose connector. |
||
Place a wooden block in caliper body as shown in the figure to prevent the piston from jumping out and avoid being damaged.
Gradually supply compressed air via the installation hole of brake hose to force the piston out.
|
(1)
|
Place a
30 mm (1.18 in) wide wooden block here.
|
Remove the piston boot.
Remove the piston seal from caliper body cylinder.
| Important | ||
|
Do not damage the cylinder and piston seal groove. |
||
|
(1)
|
Piston
seal
|
Remove the guide pin and boot from caliper body.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
