SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Important

Be sure the lining surface is free from oil and grease contamination.


Apply brake grease to the following places.

Brake grease:

Brake Grease (Part No. 32005008)


• Six contact surfaces of shoe rim and back plate packing

• Contact surface of shoe wave and anchor pin

• Contact surface of lever and strut

• Contact surface of shoe wave and adjuster assembly

• Contact surface of shoe wave and strut

• Contact surface of lever and shoe wave


Insert the primary side brake shoe into anchor pin groove.

Secure the brake shoe with shoe hold-down pin and cup.

Install the plate to anchor pin, and then assemble the primary return spring to anchor pin.


(1)

Primary return spring

(2)

Anchor pin

(3)

Plate

(4)

Primary shoe

(5)

Shoe hold-down pin & cup



Install the parking brake cable to parking brake lever.

Assemble the strut and adjuster, and then secure the secondary side brake shoe with shoe hold-down pin & cup.

Note
• Install the strut spring of both right and left wheels facing vehicle front.

• Install the adjuster assembly with screw on left side.



(1)

Left



Install the secondary return spring and adjusting spring.


(1)

Lever

(2)

Secondary brake shoe

(3)

Strut spring

(4)

Strut

(5)

Return spring

(6)

Adjuster

(7)

Shoe hold-down cup

(8)

Adjusting spring



Adjust the parking brakes.

Drive the vehicle for parking brake lining “break-in”.

Drive the vehicle at about 35 km/h (22 MPH).

With the parking brake release button pushed in, pull the parking brake lever gently.

Drive the vehicle for about 200 meter (0.12 mile) in this condition.

Wait 5 to 10 minutes for the parking brake to cool down. Repeat this procedure once more.

After breaking-in, re-adjust the parking brakes.