SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Install the oil pump to bracket.

Place the oil pump bracket in a vise. Tighten the bushing using a 12.7 mm (1/2″) type 14 mm and 21 mm box wrench until it is in contact with the oil pump mounting surface.

Important

Do not place the oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.



(1)

Bush

(2)

Nut

(3)

21 mm

(4)

14 mm

(5)

Bolt



Tighten the bolts which install the oil pump to bracket.

Tightening torque:

15.7 (1.6 kgf-m, 11.6 ft-lb)


Tightening torque:

37.3 (3.8 kgf-m, 27.5 ft-lb)


Tighten the bolts which install the power steering pump bracket.


Interconnect the pipe C and suction hose.

Tightening torque:

Eye bolt

39 Nm (4.0 kgf-m, 28.9 ft-lb)

Important

If a hose is twisted at this step, the hose may come into contact with some other parts.



(1)

Suction hose

(2)

Pipe C



Connect the connector to power steering pump switch.

Install the pulley belt to oil pump.

Check the pulley belt tension.



Tighten the bolt of belt tension.

Tightening torque:

25 Nm (2.5 kgf-m, 18.1 ft-lb)

Install the pulley belt cover.

Connect the battery ground cable to battery.

Feed the specified power steering fluid.

Important

Never start the engine before feeding the fluid; otherwise vane pump might be seized up.