SAAB WIS ONLINE

REMOVAL

REMOVAL

Disconnect the ground cable from battery.

Remove the pulley belt cover.

Loosen the belt tension adjusting bolt and generator securing bolt, and then remove the power steering pump V-belt.


Disconnect the connector from power steering pump switch.

Disconnect the pipe C and suction hose from oil pump.

Important
• Do not allow fluid from the hose end to come into contact with pulley belt.

• To prevent foreign matter from entering the hose, cover the open ends of them with a clean cloth.



(1)

Suction hose

(2)

Pipe C



Remove the bolts which install the power steering pump bracket.


Place the oil pump bracket in a vise, remove the two bolts from front side of oil pump.

Important

Do not place the oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.



Remove the bolt from the rear side of oil pump.

Disassemble the oil pump and bracket by inserting a flat tip screwdriver as shown in the figure.