INSTALLATION
| INSTALLATION |
Install the ball joint onto housing.
Tightening torque (Bolt):
50 Nm (5.1 kgf-m, 37 ft-lb)
| Important | ||
|
Do not apply grease to tapered portion of ball stud. |
||
Connect the ball joint to transverse link.
Tightening torque (Castle nut):
40 Nm (4.1 kgf-m, 30 ft-lb)
Retighten the castle nut further within 60° until a slot in castle nut is aligned with the hole in ball stud end, then insert a new cotter pin and bend it around castle nut.
Install the front wheel.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
