REMOVAL

REMOVAL

Disconnect the ground cable from battery.

Remove the bolt inside wheel house (both sides), and the clips on lower side of bumper.

Remove the rear combination light assembly.

Remove the nut and two clips (both sides).

Remove the floor box.

Remove the rear skirt trim.

Turn over the rear quarter lower trims on both sides, and then loosen the four nuts.

Disconnect the license plate light connector, and then remove the rear bumper.

Remove the E/A FORM from bumper beam.

Important
E/A FORM may easily break. Do not apply excessive force to it during removal.

Remove the bolt.

Remove the three bolts, then remove the bumper beam.

Note
In the case of right side, remove the canister first. Loosen the bolt, and then remove the bumper beam.

Remove the five clips, and then remove the bumper upper beam.

Remove the five clips, and then remove the bumper side cover.

Remove the upper bracket from body.