SAAB WIS ONLINE

ADJUSTMENT

ADJUSTMENT

Note

The rear door glass, as a rule, should be adjusted in the same manner as front door glass, although they are different in dimension. Special notes for the rear glass are given below.


Adjust the glass position using the following dimensions as a guide line.


(1)

12 mm (0.472 in)



Note
If the dimensions are smaller than the given dimensions, glass may get caught in weather strip during lifting/lowering operation. In the worst case, it may cause the glass not to be opened fully.

After adjustment, move the glass up and down to check whether it is caught.


Set the ST on glass, and then adjust the contact degree of glass using the following dimensions as a guide line.

ST 32005172 SPACER (For rear door glass of thickness 4 mm (0.157 in))


(1)

3.7 — 5.3 mm (0.146 — 0.209 in)

(2)

4.6 mm (0.157 — 0.236 in)

(3)

ST



Note
If the contact degree of rear glass is higher than necessary, glass may get caught in weather strip of center pillar corner, resulting in early wear of weather strip. Be careful when adjusting.

After adjustment, move the glass up and down to check whether it is caught.