SAAB WIS ONLINE

PROCEDURE

PROCEDURE

Passive arming (Enter the passive mode)

Note

When passive arming mode has been programmed, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE LOCKED.


To enter the passive mode

Open the driver’s door.

Remove the two clips fastening the front portion of the side sill cover with a screwdriver.


Remove the side sill cover by pulling it up.

Connect the connector (A).


Important

Use extra care to the airbag system harnesses when setting the passive mode. Disconnection of connector could result in accidental inflation of airbag system.


Note

To place the system in active arming mode, disconnect the connector (A).


Turn the ignition switch from LOCK to ON.

Install the side sill cover.

Arming the system

Turn the ignition switch to ON.

Turn the ignition switch from ON to LOCK, and remove the key from ignition switch.


(1)

ON

(2)

LOCK



Open the door, and get out of the vehicle.

Before closing the doors, lock all doors with the inside door lock levers.


Close the doors. The system will automatically arm after one minute.

Note

In the passive mode, the system can also be armed with the remote transmitter or with the power door locking switches. If the remote transmitter or power door lock switch is used to lock the vehicle, arming will take place immediately regardless of whether or not the passive mode has been selected.


Important

In passive mode, the system will automatically activate the alarm but WILL NOT automatically lock the doors. In order to lock the doors, you must either lock them as indicated in step 4) above or with the key once they have been closed. Failure to lock the doors manually will result in a higher security risk.


Disarming the system

To disarm the system, briefly press the UNLOCK/DISARM button on keyless transmitter.

Tripped sensor identification

If an electronic chirp sounds four times and the turn signal lights blink four times when you disarm the system, this indicates that the alarm was triggered. The number of times the indicator light blanks indicates what sensor caused the alarm condition.

Enter identification mode

Open the driver’s door and leave it open.

Note

Check if the battery cable is connected.


Turn the ignition switch to ON two times. (LOCK → ON → LOCK → ON → LOCK)

The indicator light will start blinking.

Number of times blinked

Vehicle state

1 time

Any door, rear gate or trunk lid has been opened.

3 times

The impact sensor in the system"s unit has been activated. This may indicate that your vehicle has been shocked or tampered with by some outside force and/or unauthorized person.

4 times

The ignition switch has been turned on, or the battery has been disconnected.



Close the door and turn the ignition switch to ON.