SAAB WIS ONLINE

In-storage car care

In-storage car care

In-storage care is obligatory for all Saab cars at intervals of max 60 days until the car is sold. The battery must be checked once a month, see Service Information 311-2009 (SE = 311-2145) . See Policies and Procedures (P and P).

Carry out the inspection and confirm it with your signature on the report. Report, see .

Refer to workshop information and procedures when rectifying faults.

Inspection and rectification points


1. Check that the paint protector is intact. If it needs to be improved, the car must first be washed so that dust and dirt will not be enclosed. Inspect the paintwork, make a note of any damage and apply new paint protector.

Important

Paint protector hardens when exposed to UV radiation and heat. It must therefore be replaced at intervals of three to six months. Six month intervals can be employed only in winter climate.

RAPGARD paint protector must only be applied to a car for maximum 3 months and must be removed after this time.

When applying new paint protector, refer to the section “Applying new paint protector”.


2. Fill the fuel tank to at least 2/3 full to prevent the fuel pump from running dry and malfunctioning of the fuel pump due to oxidation.

3. Check the battery voltage.


• The voltage should be checked within 6 hours of the engine being turned off or the battery being charged with a battery charger. Depending on the voltage reading, the following measures must be taken.

Voltage reading

Measure



Above 12.4 V

OK



Between 12.0 V and 12.4 V

Charge



Below 12.0 V

Change





• Check the level of the electrolyte and top up to the normal level as necessary.

Charging

Use a battery charger that delivers a charging current of 4-8 A. The battery terminals and covers do not require removal.

Important

Do not use so called quick-chargers.


4. Warm up the engine until the radiator fan starts (A/C or ACC in OFF position) .

5. Check the tyre pressures and adjust them if necessary to at least 3.5 bar (50 psi).


Important

If the car is parked with insufficient tyre pressure, a flat area will form on the tyres where they rest on the ground. This gives rise to vibration and makes wheel balancing more difficult.


6. Check the level of the coolant.

7. Drive the car for at least 200 metres, applying the brakes briefly and repeatedly so that the brake discs will be clean and dry.

8. Park the car facing in the opposite direction to equalize the effect of sunlight on it.

9. Open the bonnet to cool the engine down more rapidly.

10. Check the protective plastic on the seats and adjust if necessary.

11. Make sure that: The handbrake lever is released completely. Manual gearbox, engage reverse gear. Automatic transmission, set the selector lever to the P position. All windows, doors and the boot lid/tailgate are properly closed.

12. Lock the car.

13. Check the engine bay for signs of corrosion, especially on aluminium. If this is the case, treat the areas with Teroson Skyddsvax, part no. 30 15 914. Cover with a film of wax with no surplus (10-15 µm when dry). Be especially thorough on aluminium surfaces.

Important

The protective wax may well be left on as engine bay protection when the car is delivered to the customer. If the customer will not accept the waxed surface, it must of course be washed off.


Warning

Bear in mind the danger of fire. Make particularly sure that the temperature of the engine bay has dropped. Do not spray onto the ends of the generator.


14. Disconnect the positive cable from the battery or remove the battery for charging.

Close the bonnet.