Engine block
| Engine block |
| Cylinder bore |
All piston classifications may be present in the same cylinder block. The cylinder classification is stamped on the plane of the cylinder and specified for each separate cylinder.
|
Classification markings
|
|
|
|
8
|
mm
|
83.975-83.985
|
|
99
|
mm
|
83.985-83.995
|
|
00
|
mm
|
83.995-84.005
|
|
01
|
mm
|
84.005-84.015
|
|
02
|
mm
|
84.015-84.025
|
The new cylinder classification marking must be applied after reboring the cylinders.
| Cylinder block |
|
Height, new cylinder block
|
mm
|
242.2
|
| Cylinder head |
|
Height, cylinder head
|
mm
|
140 NOTE: must not be planed
|
Cylinder head gaskets
|
Level difference, pistons
|
Thickness, gasket
|
Marking
|
|
0.40 - 0.50 mm
|
1.2 mm
|
No notch
|
|
0.51 - 0.60 mm
|
1.3 mm
|
1 notch
|
|
0.61 - 0.70 mm
|
1.4 mm
|
2 notches
|
| Check values, pressure |
|
Compression
|
bar
|
32-36
(The difference between the cylinders must not exceed 10%.) |
|
Compression ratios
|
19.5:1
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
