SAAB WIS ONLINE

Replacement of balancer-shaft bearings

Replacement of balancer-shaft bearings


To remove


1. Remove the blanking-off washer.

2. Insert the tool, part no. 83 94 470, from the flywheel end and attach the pull rod with a nut.

3. Carefully remove the bearing by slowly tightening the nut.



To fit



1. Clean the bearing surface in the cylinder block.

2. Mount the bearing onto the fitting tool, part no. 83 94 470.

3. Insert the fitting tool from the flywheel end and connect the pull rod with nut.

4. Tighten the nut until the marking on the tool is aligned with the edge of the hole for the blanking-off washer. The bearing is now in the correct position.

5. Dismantle and remove the tool.

6. Make sure the oilway is open.

7. Fit a new blanking-off washer.