Engine coolant temperature sensor
|
|
Engine coolant temperature sensor
|
|
1.
|
Open the cap on the expansion tank to release the pressure. Screw back on the cap.
|
|
2.
|
Remove the engine cover.
|
|
3.
|
Unplug the temperature sensor connector.
|
|
4.
|
Place a receptacle under the engine and remove the temperature sensor.
|
|
1.
|
Fit the temperature sensor with a new seal.
Tightening torque 18 Nm (13 lbf ft).
|
|
2.
|
Plug in the temperature sensor connector.
|
|
4.
|
Fill with coolant, check the integrity of the system and bleed it as follows:
|
Note
|
|
AC/ACC must be turned off.
|
Connect exhaust hoses to both the engine exhaust system and the auxiliary heater exhaust system and start the engine.
Start the parking heater with the diagnostic tool (Body, SID, Activate, Heater). The parking heater stops when the engine temperature has reached 85°C or on exiting the parking heater menu.
Make sure there is a continuous flow of coolant in the hose from the thermostat housing to the expansion tank.
Run the engine until the thermostat opens.
|
|
5.
|
Turn off the engine and carefully open the cap on the expansion tank. Top up to MAX level. Close the cap.
|
