Front exhaust pipe with three-way catalytic converter (Turbo)
|
|
Front exhaust pipe with three-way catalytic converter (Turbo)
|
|
Important
|
|
The exhaust pipe's flexible section is highly sensitive to bending and must not be bent more than about 5°, as this could result in permanent deformation.
|
|
Do
not
allow the catalytic converter to hang from the flexible section.
|
|
|
|
1.
|
Remove the heat shield over the exhaust manifold.
|
|
2.
|
Unplug the oxygen sensor's leads, undo the clip and the upper cable clamp.
|
Important
|
|
The leads must not be twisted. The oxygen sensor is sensitive to knocks and blows and must be handled with care.
|
|
|
|
|
3.
|
Remove the lower cable clamp and oxygen sensor.
Raise the car.
|
|
4.
|
Loosen the joint between the front exhaust pipe and the middle pipe.
|
|
5.
|
Unscrew the front exhaust pipe from the turbocharger.
|
|
6.
|
Detach the exhaust pipe from the rubber mounting on the engine subframe and lower the exhaust pipe.
|
|
2.
|
Position the front exhaust pipe and secure it to the turbocharger. Before fitting, lubricate the three studs on the turbocharger with Molycote 1000, part No. 30 20 971.
Tightening torque: 25 Nm (18.5 lbf ft)
|
|
3.
|
Attach the exhaust pipe to the engine subframe with the rubber mountings from the catalytic converter. If necessary, use new rubber bushes.
|
|
4.
|
Screw together the joint at the intermediate pipe, using a new clamp.
Tightening torque: 20 Nm (15 lbf ft)
|
Important
|
|
To avoid leakage, use new clamps when tightening the joints.
|
|
|
|
|
5.
|
Lower the car to the floor.
Fit the oxygen sensor, but first lubricate the threads with Molycote 1000, part No. 30 20 971.
Tightening torque: 55 Nm (41 lbf ft)
|
Important
|
|
The oxygen sensor is sensitive to knocks and blows and must be handled with care. It is important to ensure that the connection between it and the nipple is gastight.
|
|
The oxygen sensor's lead must not be stretched between engine and exhaust pipe. Secure the cable to the clips so that a loop is formed just before the sensor.
|
|
|
|
|
6.
|
Run the cable up, connect it and fit the connector in the holder.
|
Important
|
|
Watch out for sharp edges and hot components.
|
|
|
Secure the cable to the turbo's coolant pipe, using a cable tie.
|
|
7.
|
Fit the heat shield over the exhaust manifold.
|
