SAAB WIS ONLINE

Fuel pressure regulator

Fuel pressure regulator

Warning

Removal of the fuel pressure regulator involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:

Work only in a well-ventilated area! If approved equipment for the extraction of fuel vapours is available, be sure to use it.

Wear suitable gloves! Prolonged contact with fuel can cause skin irritation or dermatitis.

Keep a class BE fire extinguisher close at hand! Beware of sparks caused by short circuits and when connecting and disconnecting leads in electrical circuits.

No smoking anywhere in the vicinity.


To remove




Important

To minimize any residual fuel pressure, remove the fuel pump fuse no. 32 while the engine is idling. Turn off the ignition once the engine has stopped. Refit the fuse.



1. Remove the vacuum hose.

2. Unscrew the bolt and open the clamp.

3. Pull out the pressure regulator.


To fit



1. Press on the pressure regulator.

2. Fit the clamp and bolt.

3. Fit the vacuum hose.


Important

Grease the O-ring before fitting.