Air collector casing
| Air collector casing |
| 1. |
Undo the hose clip securing the rubber elbow to the mass air flow sensor.
|
|
| 2. |
Undo the snap fasteners holding the cover in place.
|
|
| 3. |
Lift off the cover and remove the filter element.
|
|
| 4. |
Undo the bush nuts keeping the air collector casing in place.
|
|
| 5. |
Lift out the air collector casing and connection pipe from the resonator.
|
|
| To fit |
| 1. |
Position the air collector casing and make sure the connection to the resonator pipe is correct.
|
|
| 2. |
Tighten the bush nuts securing the air collector casing.
|
|
| 3. |
Clean the air collector casing (the lower part of the air cleaner).
|
|
| 4. |
Fit a new filter as illustrated.
|
|
| 5. |
Position the mass air flow sensor in the rubber elbow on the air collector casing cover. Make sure the projecting lugs on the mass air flow sensor fit into the recesses in the elbow.
|
|
| 6. |
Position the air cleaner cover, press on the snap fasteners and tighten the hose clip.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
