Generator, diesel engine, LHD
Generator, diesel engine, LHD |
Note | ||
If the car is fitted with a radio other than Saab's original, check that the customer has the radio code before you begin work. |
1. |
Disconnect the battery's negative cable.
|
2. |
Raise the car.
|
3. |
Remove the cover under the car.
|
4. |
Remove the cover over the belt circuit.
|
5. |
Slacken the multigroove V-belt and disengage it from the generator.
|
6. |
Undo the generator's connecting cables.
|
7. |
Remove the bolt from the lower generator bracket.
|
8. |
Lower the car.
|
9. |
Drape protective covers over the front wings.
|
10. |
Remove the contact housing of the mass air flow sensor.
|
11. |
Remove the air hose, including the mass air flow sensor, between the air filter and the engine.
|
12. |
Disengage the fuel hoses from their attachments.
|
13. |
Snip the belt tie holding the hoses to the supplementary heater.
|
14. |
Disconnect the hose leading to the control valve's wastegate under the turbocharger.
|
15. |
Detach the wastegate.
|
16. |
Remove the upper retaining bolt of the generator.
|
17. |
Raise the generator.
|
To fit |
1. |
Clean the attachment points of the generator and coat them with Vaseline so as to prevent oxidation.
|
2. |
Put the generator into position.
|
3. |
Secure it with the upper bolt, without making it really tight.
|
4. |
Raise the car.
|
5. |
Fit the bolt of the lower bracket.
Tightening torque: 35 Nm (26 lbf ft). |
6. |
Mount the belt, check its position on all pulleys and remove the tension reliever so that the belt is tensioned.
|
7. |
Refit the generator's connecting cables.
|
8. |
Fit the cover over the belt circuit.
|
9. |
Put the lower cover back into place.
|
10. |
Lower the car.
|
11. |
Make the upper bolt tight.
Tightening torque: 35 Nm (26 lbf ft). |
12. |
Fit the control valve's wastegate.
|
13. |
Connect the hose to the wastegate.
|
14. |
Apply a new strap tie to hold the hoses of the supplementary heater.
|
15. |
Replace the air hose with the mass air flow sensor between the air filter and the engine.
|
16. |
Refit the fuel hoses.
|
17. |
Connect the contact housing to the mass air flow sensor.
|
18. |
Connect the battery's negative cable.
|
19. |
Set the clock and program in the radio code if any.
|