B1160
Read the instructions below then start the fault diagnostic procedure.
Symptom: Dipped beam does not work. Dipped beam malfunction
| B1160 |
Dipped beam relay
Fault symptoms
Dipped beam does not work.Dipped beam malfunction
Condition
The control module output is monitored and a DTC generated if the following occurs:| • |
Open/short circuit to ground.
|
|
| • |
Shorting to battery positive B+.
|
|
DTCs are not generated if the voltage is below 11V or during diagnostic communication.
Diagnostic help
The output from DICE can be activated with the diagnostic tool.DTCs are not generated if the voltage is below 11 V or during diagnostic communication with DICE.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
