CHECK messages

CHECK messages

General

The SID unit can be used by all connected systems to show CHECK messages. When the ignition is turned ON, “CHECKING” appears for approx. 4 seconds, after which a CHECK message is shown if one is active.

The message “KEY NOT ACCEPTED” is displayed without the 4-second delay.

If a CHECK message is initiated, an acoustic signal is heard, the INFO DISPL lamp in the main instrument unit lights and a message is shown. If the message is preceded by a (+) sign, more than one message has been activated.

CHECK messages are shown in the following order of priority:

1.	KEY NOT ACCEPTED

2.	TIGHTEN FUEL FILLER CAP

3.	CHECK SOFT TOP STORAGE

4.	CLOSE TRUNK LID

5.	CHECK SOFT TOP LATCHES

6.	FINISH SOFT TOP MOTION

7.	CHECK SOFT TOP COVER

8.	SOFT TOP FAILURE

9.	CHECK SOFT TOP

10.	STOP FOR FUEL

11.	TRANSMISSION OVERHEATING

12.	BRAKE LIGHT FAILURE

13.	FRONT LIGHT FAILURE

14.	FOG LIGHT FAILURE

15.	REAR LIGHT FAILURE

16.	TEST BRAKE LIGHTS

17.	WASHER FLUID LEVEL LOW

18.	FILL COOLANT FLUID

19.	SERVICE THEFT ALARM

20.	REPLACE KEY BATTERY

21.	TIME FOR SERVICE

WASHER FLUID LEVEL LOW is displayed after a 70-second delay and FILL COOLANT FLUID is displayed after a 30-second delay (not when ignition ON “CHECKING”).

The driver acknowledges a message by pressing any button except NIGHT PANEL. If more than one message is activated, the next message is displayed in the same way. When a message has been acknowledged, it is not shown again.

TEST BRAKE LIGHTS cannot be acknowledged as above, but disappears only when the brake pedal is pressed.