Glass breakage sensor
Glass breakage sensor |
Note | ||
The glass breakage sensor is not stocked separately as a spare part. The complete lens cover must be replaced. |
1. |
Release the lens cover on the centre roof light.
|
2. |
Loosen the switch panel on the roof lamp by pressing it forwards and at the same time pulling the rear edge downwards.
|
3. |
Release the electrical connector from the sensor and lift off the lens cover.
|
To fit |
1. |
Replace the connector. Ensure that the connector is properly seated and attached to avoid vibrations.
|
2. |
Fir the switch panel. Start with the front edge and push it forwards. Then press the rear edge upwards.
|
3. |
Fit the lens cover.
|