SAAB WIS ONLINE

Tilt sensor

Tilt sensor

To remove



1. Remove the antenna unit by turning it clockwise. Lift the unit up and disconnect the electrical connector.

2. Remove the ignition switch cover. Start at the back as it is fastened with hooks at the front.

3. Unscrew 2 screws holding the floor console.

4. Remove the rear section of the floor console.

5. Unscrew 2 nuts holding the floor console.

6. Remove the switch. Bend at the front edge.


7. On the Cabriolet, remove the interior lighting switch.

8. Loosen the remote control receiver from the side wall of the floor console.

9. Disconnect the electrical connector from the receiver unit.

10. Lift off the floor console.

11. Lift the floor duct.


12. Remove the tilt sensor from its holder (slides off).

13. Disconnect the electrical connector from the tilt sensor.


To fit



1. Fit the connector to the tilt sensor.

2. Fit the sensor on its holder.

3. Fit the floor duct in position.

4. Fit the floor console in position.


5. Fit the switch.

6. Fit the remote control receiver.

7. Fit the connector on the receiver.

8. Screw the floor console in position with the 2 screws and 2 nuts.


9. Fit the rear section of the floor console.

10. Fit the ignition switch cover.

11. Fit the antenna unit.