Wiring harness, roof
Wiring harness, roof |
Changing |
Note | ||
If the car is fitted with a radio other than a Saab original radio, check that the customer has the radio code before you begin work. |
1. |
Disconnect the negative lead of the battery.
|
2. |
Remove the side trim from the left-hand side of the luggage compartment, see
|
3. |
Remove the headlining, see
|
4. |
Mark all connectors meticulously
before unplugging them from their components.
|
5. |
Unplug the connector at the rear LH wheel housing.
|
6. |
Cautiously detach the wiring harness so as not to spoil those cable ties, etc., that are to be re-used.
|
7. |
Run the new wiring harness the same way as the old one and fasten it in the same manner. Make sure that all grommets seal properly.
|
8. |
Plug the connectors to their components. In case of doubt, check against the wiring diagrams and component lists pertaining to the system you are working on.
|
9. |
Put the connector back together.
|
10. |
Re-fit the headlining and the luggage compartment lining.
|
11. |
Connect the negative lead to the battery. Reset the clock and program in the radio code if there is one.
|
Important | ||
Fasten the wiring harness correctly so that there is no risk of it scraping or rattling. |
||
Check all rubber grommets to minimize the risk of leakage. |
||
|
||
Note | ||
Spray all the connectors with “Kontakt 61” to prevent corrosion; clean all the grounding points and apply vaseline. |