Wiring harness, side airbag, LH side
|
Wiring harness, side airbag, LH side
|
Warning
|
The joining of SRS cables is forbidden.
|
Joining can cause functional disorders that make the system unusable and can lead to personal injuries
|
|
|
|
|
Note
|
If the car is fitted with a radio other than a Saab original radio, check that the customer has the radio code before you begin work.
|
1.
|
Disconnect the negative lead of the battery.
|
3.
|
Remove the floor console.
|
4.
|
Remove the LH outer side panel.
|
5.
|
Remove the LH bottom portion of the dashboard and the knee shield.
|
6.
|
Remove the scuff plate from the LH front door.
|
7.
|
Bend aside the mats at the door sill and seat member.
|
8.
|
Unplug the LH door switch.
|
9.
|
Prise out the green/blue wire from pin 27 and the yellow/green wire from pin 26.
|
10.
|
Place the spare parts harness behind the grounding points.
|
11.
|
Prise in the spare parts harness' green/blue wire in pin 27 and the yellow/green wire in pin 26.
|
12.
|
Place the spare parts harness along the sill up to the seat member. Follow the seat member to the floor console with the portion of the spare parts harness that has four wires.
|
13.
|
The portion of the spare parts harness that has yellow/blue and brown/blue wires is pulled along the wiring harness to the seat.
|
14.
|
Unplug the connector to the seat.
|
15.
|
Prise out the yellow/blue wire from pin 9.
|
16.
|
Prise in the yellow/blue wire from the spare parts harness in pin 9.
|
17.
|
Prise out the brown/blue wire from pin 7.
|
18.
|
Prise in the brown/blue wire from the spare parts harness in pin 7.
|
19.
|
Put the connector back together.
|
20.
|
Unplug the 16-pin connector in front of the airbag control module.
|
21.
|
Prise out the green/blue wire from pin 14 and the yellow/green wire from pin 13 in the connector.
|
22.
|
Prise in the spare parts harness' green/blue wire in pin 14 and yellow/green wire in pin 13.
|
23.
|
Put the connector back together.
|
24.
|
Unplug the black 2-pin connector in front of the airbag control module.
|
25.
|
Connect the spare parts harness' 2-pin switch with the car's harness.
|
26.
|
Isolate all removed pins with tape and tape them up against the wiring harness so that they do not cause rattles.
|
29.
|
Fit the outer side panel.
|
30.
|
Fit the floor console.
|
32.
|
Connect the battery's negative lead.
|
33.
|
Start the engine and check to make sure the airbag lamp does not light.
|
34.
|
Erase all DTCs in SRS.
|
35.
|
Set the clock and program the radio code if applicable.
|